Description:

[Folds small etched parts accurately] 

This is a dedicated vendor that can accurately fold small etched parts that have no broken line engravings.

The gripping surface has a flat finish, so you do not need to worry

about scratching the parts even if it is held firmly.

The grabbing part has a trapezoidal cross section. 

When etching parts are bent, even if the angle returns slightly due to the repulsive force of the metal, it can be bent more than 90 degrees, so it is easy to make a right angle without any special technique.

The tip and side of the grip can be used as well.

Small parts can be bent using a tip that is cut into a chevron.

By using the side, you can bent a fold line up to about 45mm at a time.

The grip is made of soft resin that is not slippery and adapts well to the hand.

[Basic Specifications]
The grabbing part is made of stainless steel and the grip is made of soft resin

Mini version is also available